COATS 1100 Series Balancer - Manual (Page 10)

6 • Important: Always read and follow instructions.
Note: Throughout this manual, wheel weights are
referred to as Clip-on or Tape-A-Weight®. Figure 4
shows an example of each weight.
Figure 4 - Corrective Weight Examples. For Best Results, use
BADA® Brand Wheel Weights.
Power Switch
The ON/OFF switch location (figure 5) is at the back
of the balancer; below the weight tray.
Figure 5 - On/Off Switch
Using The Offset Arm
When not in use or when prompted by the balancer
instructions, store the offset arm in the home position
as shown in figure 6.
Figure 6 - Location of Offset Arm (Stored In Home Position)
When prompted by balancer instructions, use the
offset arm (figure 6) to enter A & D measurements
automatically. Pull the arm out and up against the wheel
flange; hold it still at the clip-on weight location (figure
7), against the wheel flange, and wait for the BEEP.
Figure 7- Automatic A & D Measurement At Clip-on Weight
Location
ON/OFF
Power
Switch
Offset Arm
In Home
Position
Clip-on Weight Tape-A-Weight ®