DATOptic uNAS – tNAS - Manual (Page 20)

uNAS/tNAS User Guide Version 1.0 Page 20
• balance-xor: Transmit based on [(source MAC address XOR'd with destination MAC
address) modulo slave count]. This selects the same slave for each destination MAC
address. This mode provides load balancing and fault tolerance. This mode provides fault
tolerance and load balancing.
• broadcast: Transmits everything on all slave interfaces. This mode provides fault tolerance.
• 802.3ad: IEEE 802.3ad Dynamic link aggregation. Creates aggregation groups that share
the same speed and duplex settings. Utilizes all slaves in the active aggregator according to
the 802.3ad specification. Requires a switch that supports IEEE 802.3ad Dynamic link
aggregation.
•
balance-tlb: Channel bonding that does not require any special switch support. The
outgoing traffic is distributed according to the current load (computed relative to the speed)
on each slave. Incoming traffic is received by the current slave. If the receiving slave fails,
another slave takes over the MAC address of the failed receiving slave. This mode provides
fault tolerance and load balancing.
Function: HTTP proxy
With this function you can enable or disable HTTP proxy.
To enable HTTP proxy:
• select "Use HTTP proxy"
• enter server name, port, user and password
• click "apply" button