DATOptic uNAS – tNAS - Manual (Page 72)

uNAS/tNAS User Guide Version 1.0 Page 72
Source share - In order to set share as source, select it from the drop down list and enter
Destination IP, Where share will be replicated.
Snapshot - Snapshot assigned for data replication.
Destination share - Select destination share from the drop down list and enter destination
agent login and password.
Dest. agent login - Enter destination agent login.
Dest. agent password - Destination agent password.
Log replication errors - Turn it on, if you want to log replication errors.
Replicate whole files - If this option is turn on, then all parts of a file will be replicated, if not
only changed part of a file will be replicated. It's recommended to turn it on, if speed of network
is faster then local partition write speed. In order to set share as a destination, one should
enable Data replication agent in setup NAS settings menu, then enable replication option for
each share. There is no need to enable Data replication agent, if replication would be only set
as source. It's not possible to make data replication and backup in the same time. Backup has
higher priority then data replication. Data replication will be stopped, if it has been setup in the
same time with Backup, when using snapshots from the same Logical Volume. You will see
snapshot error in Data replication status, because snapshots can not be used twice in a same
time, if they are set to the same Logical Volume. In order to make data replication over the
internet you have to configure the firewall port to: 873.
Function: Data replication tasks
Here you can run, stop and delete previously created data replication tasks.
For every task you can view additional details:
• Destination IP,
• Source share,
• Snapshot,
• Destination share,
• Destination agent login,
• Replicate whole files info,
• Log replication errors info.