DATOptic uNAS – tNAS - Manual (Page 30)

uNAS/tNAS User Guide Version 1.0 Page 30
Include array status
Information about the status of event-related array will be added every event.
Function: Drive identifier
This function helps find disks in the cage of your NAS server. In case of hardware RAID
installed, the whole RAID array is shown as a single drive. In this case you may not be able to
determine which drive unit is which disk when using S.M.A.R.T. tool or hardware RAID
management tool (depends on manufacturer of RAID controller).
When you click on "start" button then the appropriate disk will start reading and you can
determine which disk is it by watching "disk-activity LEDs". For proper operation of this function
there should be no other activity on hard drives. Identification will stop automatically after one
minute if you will not stop it before (by unsetting appropriate checkbox and applying form).
Using this function during normal operation is not highly recommended and will cause of your
server to slow down.