Det-Tronics X5200 UVIR Flame Detector - Manual (Page 3)

1 95-8546 13.1
Important
Be sure to read and understand the entire
instruction manual before installing or operating
the flame detection system. Any deviation from
the recommendations in this manual may impair
system performance and compromise safety.
attEntIon
The X5200 includes the Automatic oi ® (Optical
Integrity) feature — a calibrated performance test
that is automatically performed once per minute
to verify complete detector operation capabilities.
testing with an external test lamp is not
approved or required.
DESCRIPTION
The X5200 UVIR Flame Detector meets the most
stringent requirements worldwide with advanced
detection capabilities and immunity to extraneous
sources, combined with a superior mechanical design.
The mounting arrangement allows the UV and IR sensors
to monitor the same hazardous location with a 90 degree
cone of vision. When both sensors simultaneously detect
the presence of a flame, an alarm signal is generated.
The detector has Division and Zone explosion-proof
ratings and is suitable for use in indoor and outdoor
applications.
The standard output configuration includes fire, fault and
auxiliary relays. Output options include:
– 0 to 20 mA output (in addition to the three relays)
– Pulse output for compatibility with existing Detector
Electronics Corporation (Det-Tronics ® ) controller
based systems (with fire and fault relays)
– Eagle Quantum Premier ® (EQP) compatible model
(no analog or relay outputs)
– HART communication
A tri-color LED on the detector faceplate indicates
normal condition and notifies personnel of fire alarm or
fault conditions.
Microprocessor controlled heated optics increase
resistance to moisture and ice.
The X5200 housing is available in copper-free aluminum
or stainless steel, with NEMA/Type 4X and IP66/IP67
rating.
OuTpuTs
Relays
The standard detector is furnished with fire, fault and
auxiliary relays. All three relays are rated 5 amperes at
30 Vdc.
The Fire Alarm relay has redundant terminals and
normally open / normally closed contacts, normally
de-energized operation, and latching or non-latching
operation.
The Fault relay has redundant terminals and normally
open contacts, normally energized operation, and
latching or non-latching operation.
INsTRuCTIONs
UVIR flame Detector
X5200
© Detector Electronics Corporation 2013 Rev: 10/13