Det-Tronics X3300 Protect-IR Multispectrum IR Flame Detector - Manual (Page 9)

INSTALLATION OF X3300 WITH INTEGRAL SWIVEL
MOUNT
Refer to Figures 6A, 6B, 6C and 6D and follow the
instructions below to install the X3300 with Integral
Swivel Mount. Perform steps 1 through 4 on a
workbench before installing the unit on the wall or
ceiling.
NOTE
The greatest mechanical stability will be achieved if
the device is installed such that the weight of the
device tends to tighten the adapter (see Figures
6C and 6D).
1. Install the adapter on the appropriate junction box
conduit entry. Remove the nut, then thread the
adapter onto the junction box.
2. Thread the X3300 wires through the adapter and
into the junction box.
3. Connect the X3300 to the adapter using the two
allen head screws to fasten the integral swivel
mount to the adapter.
4. Estimate the orientation and sighting of the X3300 to
best view the hazardous area while still on the
workbench, then tighten the adapter nut and the
sighting screws.
5. Install the junction box on the wall or plate and route
the field wiring through the appropriate conduit
entry.
7 95-8480
A1927
ADAPTER NUT ADAPTER
X3300 DETECTOR/CONTROLLER
PARTS IDENTIFICATION
INTEGRAL SWIVEL JUNCTION BOX
(NOT SUPPLIED)
Figure 6A—X3300 with Integral Swivel Mount Installation
INSTALL THE ADAPTER ON THE APPROPRIATE JUNCTION BOX CONDUIT ENTRY.
REMOVE THE NUT, THEN THREAD THE ADAPTER ONTO THE JUNCTION BOX.
A1928
Figure 6B—X3300 with Integral Swivel Mount Installation