ElmoMC ExtrIQ Digital Servo Drives-Hornet - Manual (Page 22)

Hornet and Bee Installation Guide Installation
MAN-HRBEIG (Ver. 1.304)
www.elmomc.com
22
3.4.2. Bee
The Bee was designed for mounting on a printed circuit board (PCB) via 2 mm pitch 0.51 mm
square pins. When integrating the Bee into a device, be sure to leave about 1 cm (0.4")
outward from the lower board to enable free air convection around the drive. We recommend
that the Bee be soldered directly to the board. Alternatively, the Bee can be attached to socket
connectors mounted on the PCB.
Note: Elmo recommends you leave approximately 1 cm (0.4 in) of space on the side opposite
the terminals to allow for free air convection.