Environmental Express AutoBlock III - Manual (Page 11)

TOUCH SCREEN CONTROLLER
The touch screen controller is specifically designed for use with the AutoBlock. Once the system is
turned on, the AutoBlock software will automatically load. Pressing the screen tabs or input boxes with
the attached stylus activates the touch screen. It is not necessary to push very hard, this may damage
the screen.
Manual Tab
Main Screen Functions
There are several operations that appear permanently on the touch screen.
There are FIVE tabs of operation located at the top of the touch screen:
MANUAL RUN PROGRAM SERVICE EXIT
The MANUAL screen will appear at start up.
-A pop up message will appear: “READY TO HOME MOTORS?” Press the Continue button.
-Motors will activate to initialize in their home positioning.
-A pop up message will appear: “MOTORS ARE HOMED” Press the Continue button.
To switch between tabs, press the appropriate tab with the stylus. Each tab will be described in this
manual to allow the analysts to fully operate the AutoBlock.
The main screen will go into sleep mode when left unattended. Touch the top of the screen with the
stylus to awaken.
Sensor Indicators
Alarm sensors are located in the upper left portion of the screen and when triggered change color. These
sensors may take a few moments to change its status, it is not instantaneous.
P Pressure Sensor
Located in the Exhaust Compartment. Detection if a pressure drop has occurred.
Green light will indicate a positive operating state
Red light will indicate the sensor has been activated & needs attention.
L Leak Detector Sensor
Located in the Pumping Compartment. It will detect if there is a leak present.
Green light will indicate a positive operating state
Red light will indicate the sensor has been activated, immediate attention should be given to this
situation. The AutoBlock will not operate until the leak has been resolved. Reference Start Up
Instructions–Sensor Validation section of this manual for addition information.
ENVIRONMENTAL EXPRESS
For technical support call 1-800-745-8218 or send email to [email protected]
5528TOUCHCREEN Rev 2 11 9/10/09