ETC Desire Series XTI v1.6.0 - Manual (Page 21)

1
Installation and DMX Profiles 16
Accessory Installation
Accessories, such as grid louver, half shield, and lenses, are installed on the front of the fixture
without compromising the integrity of the water-tight seal. Secondary lenses are secured with the
trim ring and can be rotated while they are on the fixture, allowing you to focus the beam precisely.
For detailed information, refer to the following accessory installation instructions that are packaged
with the accessory.
• D40/D60 XTI Grid Louver Installation Instructions
• D40/D60 XTI Half Shield Installation Instructions
• D40/D60 XTI Secondary Lens Installation Instructions
Figure-1.2 Trim Ring and secondary lens installation.
Installation on a Permanent Base
Install on a suitable, rigid, permanent base with secured bolts. This can include poured
concrete pads on the ground or a solid structure such as on top of a concrete wall. For
mounting, use the full-sized template that is included in the installation instructions or
download the template at www.etcconnect.com.
Refer to the D40/D60 XTI Installation Instructions.
Installation on a Pole
A Single fixture or Twin fixture pole mount is used to attach the D40/D60 XTI fixture to a
pole. The Single fixture pole mount fits nominal 2-3/8 inch poles and the twin pole mount
fits nominal 4 inch poles. Both mounts can be rotated for focusing. The twin mount allows
you to attach two fixtures side-by-side on one pole.
Refer to the D40/D60 XTI Pole Mounts Installation Instructions.
W A R N I N G : Make sure all accessories are securely in position before installing the
fixture.
Trim Ring