EUCHNER CETx-AR-xxx-CH-xxx (Multicode) - Manual (Page 4)

Operating Instructions Safety Switch CET.-AR-...-CH-...
4
Important:
Ì The user is responsible for the integration of the device into a safe overall
system. For this purpose, the overall system must be validated, e.g. in ac-
cordance with EN ISO 13849-2.
Ì Correct use requires observing the permissible operating parameters (see
Technical data).
Ì If a product data sheet is included with the product, the information on the
data sheet applies in case of discrepancies with the operating instructions.
Ì In the estimation of the PL for the overall system, a maximum value of
100 years can be assumed for the MTTF
d
according to the limit value in
EN ISO 13849-1:2008, section 4.5.2. This corresponds to a minimum
value for the PFH
d
of 2.47 x 10 -8 /h. When up to 11 devices are connected
in series, these limit values can be assumed for the entire switch chain as a
subsystem. As a subsystem, this switch chain achieves PL e. If more than
11 devices are connected in series, the PFHd can be calculated using one of
the methods stated in EN ISO 13849-1:2008, Section 4.5.1.
Ì If the simplified method according to Section 6.3 of EN ISO 13849:2008-12
is used for validation, the Performance Level (PL) might be reduced when
more than 11 devices are connected in series.
Ì It is only allowed to use components that are permissible in accordance with
the table below.
Possible combinations for CES components
Safety switch
Actuator
CET-A-BWK-50X
096327
CET.-AR-...-CH-...
Key to symbols Combination possible
Note:
For information about combination with an AR evaluation unit, please refer to the
section Information on operation on an AR evaluation unit on page 32.
Exclusion of liability and warranty
In case of failure to comply with the conditions for correct use stated above, or
if the safety instructions are not followed, or if any servicing is not performed as
required, liability will be excluded and the warranty void.