EZWatch Evolution - Manual (Page 22)

1.2 PTZ Camera Control
Control the movement of PTZ cameras. With cameras that support PTZ control, you can move, zoom, patrol,
adjust the focus, and set preset points of the cameras.
1.2.1 Set Preset Point / Go to Preset Point
Adjust the camera view until you are satisfied. Click on the Set icon and set up the view as the preset point
01. Adjust the camera view again and set up the preset point 02. Repeat the process until finish setting up all
preset points. You can enter any names you want instead of the preset point 01, preset point 02, preset point
03…, click on the Go icon and view the result of your setting.
Note: For the speed settings of PTZ camera, go to Config – Setting - PTZ Config to setup the advanced
settings.
1.2.2 Zoom
Click on the + and – signs to zoom in and zoom out the view.
1.2.3 Focus
You can select to have the camera focused near or far. Click on Focus Near to focus on objects closer
to the camera. Click on Focus Far to focus on objects further away from the camera. Click on Auto
Focus if you want the system to decide the focus point for
you.
1.2.4 Patrol
Go to Set Preset Point - Set Patrol to obtain the Patrol Setup
dialog. From the left window, select the cameras that you
would like to have in the patrol group. Align the cameras in
order in the right window and adjust the time. Rename the
group name if required. After completing the setup, check the
Active option, and then click OK.
Note: You can define up to four groups of auto patrol. To
start or stop, click on Go to Preset Point in the Main
Console, and select Start Patrol or Stop Patrol.
PTZ Camera
Control
Set Preset Point / Go to Preset Point
Zoom Out / Zoom In
Focus Far
/ Auto Focus
/ Focus Near