EZWatch Evolution - Manual (Page 60)

Step 1: Select the “PTZ Preset Go” action and then click OK.
Step 2:
The responding window will pop up to PTZ Camera Preset Go. Click the “PTZ Preset Go” indicator to
modify the setting.
Step 3:
Set the action of cameras which you want to trigger by events.
For example: Please follow below steps to setup this function.
 Set the action of camera 1:
1. Choose camera 1.
2. Set the start, end preset points.
3. Select the Life Cycle.
4. Click on Add.
 Set the action of camera 2:
5. Choose camera 2.
6. Set the start patrol and end patrol.
7. Select the Life cycle
8. Click on Add.
9. Finally click on Ok to save all setting of cameras.
Note: Configure your PTZ camera before using this function. See Config on page 69 for PTZ camera
configuration.
4.2.7 Action Type – DI/DO
To trigger Digital input/output devices connected to the system, such as alarm lights and sirens.
Step 1:
Select the “DI/DO” action and then click OK.
Step 2:
The responding window will prompt user to Select Digital Input Module. Click the “DI/DO” indicator to
modify the setting.
Step 3:
Select the device that is connected to your system, that is, the PC you are working with. You can
enable the Automatically Popup I/O Control Panel
check box to obtain the correspondent panel to
monitor the I/O status.
Note: You should adjust the setting of I/O device in
Config>Setting>I/O Device first, the I/O control panel
will display the device status based on it. You can also
adjust the size of the panel by dragging a mouse or
click the
on the right top of the display
window.
4.2.8 Action Type –Send an SMS message
The system will send an SMS message immediately to
given accounts indicating the type and time of
event.
* Note: This function is not available under Lite License.