INFICON 2020ppbPRO Portable Photoionization Detector - Manual (Page 79)

ISP-074-576-P1D 73
Off-Line Charger
General Information
The off-line charger (Part No. MX350019) allows you to charge a battery pack
independently of the 2020ppbPRO. To charge a battery pack without removing it
from the 2020ppbPRO, see Battery Charging on page 39.
The off-line charger requires one of the following the 2020ppbPRO accessories for
operation:

AC Adapter (Part No. MX350002 - North America)

AC Adapter (Part No. MX396013 - Europe)

DC Power Cord (Part No. MX350004)
Use only the AC adapter specified for use with the 2020ppbPRO. Using another AC
adapter will result in damage to the battery pack, the off-line charger, or the adapter.
Charging from an AC Source
NOTE: Do not charge the battery pack in a hazardous location.
To re-charge your battery pack:
1. Remove the battery pack as outlined in Battery Charging on page 38.
2. Attach the connector from the battery pack to the socket on the off line
charger.
NOTE: The connector is polarized. It will only fit one way. Do not force the connection.
3. Plug the AC adapter into the jack on the opposite face of the off-line
charger.
4. Plug the AC adapter into an AC outlet. If you are using the European
AC adapter, ensure the correct plug is installed on the line cord. If it is
not correct for the wall outlet in your area, then it must be replaced.
5. The LED on the upper face of the off-line charger indicates the charge
state of the battery pack. Red indicates the battery is being charged.
Green indicates the battery is fully charged.
6. Charging a fully discharged battery pack will take approximately four
hours.
7. It is normal for a fully charged battery pack to indicate it is charging (red
light) when first plugged in. The LED will turn green within a few minutes
to indicate the battery is fully charged.