INFICON 2020ppbPRO Portable Photoionization Detector - Manual (Page 83)

ISP-074-576-P1D 77
to avoid loss of data. See Battery Charging on page 38 for instructions on charging
the battery.
Please observe the following:

For replacement battery pack use only Part No. MX700010 or MX700011.

Do not dispose of the battery pack in a fire. The cell may explode.

The battery pack is 24% cadmium (Cd) by weight. This battery pack must be
disposed of properly. Check with local codes for special disposal instructions.

Do not open or mutilate the battery pack.

Exercise care in handling battery packs in order not to short the terminals with
conducting materials such as rings, bracelets and keys. The battery or
conductor may overheat and cause burns.

Charge the battery pack using the AC adapter provided with or identified for use
with this product only in accordance with the instructions and limitations
specified in this manual. For AC adapter use only Part No. MX350002 (North
America) or MX396013 (Europe).
Maintenance of the UV Lamp
Removing and Replacing the UV Lamp
NOTE: Do not remove or replace the UV lamp in a hazardous location.
To remove the UV lamp from your instrument:
1. Ensure the instrument is turned off.
WARNING
You must turn the instrument off before removing the lamp cover.
2. Remove the lamp housing cover.
3. Tilt the 2020ppbPRO slightly and remove the UV lamp.
WARNING
Do not touch the wire grid inside the detector cell. Any dust or dirt in the
detector cell can be blown out with a gentle jet of compressed air.
Do not insert any object, other than the UV lamp, into the lamp holder.
4. Without touching the lamp window, place the new lamp into the
2020ppbPRO lamp holder, window first. See Figure 21.