Barco Coronis Fusion MDCC 6130 - Manual (Page 39)

Display parts, controls and connectors
39
USB 2.0 devices are supported.
Note: The Barco Coronis Fusion 6MP Display disposes of 2
video inputs. You can connect both video inputs or just one
input.
• When both inputs are used (DuoView), the signal on the “left”
DVI connector (6) is shown on the left side of the screen and
the signal on the “right” DVI connector (7) is shown on the
right side of the screen. The video resolution of both signals
must not exceed 1640x2048 pixels if you wish to display both
signals seamlessly side by side. If the video resolution is
higher, you can select to display only one input instead of
both.
Note: For plug-and-play graphic boards (e.g., Barco display
controller(s) for your B
ARCO
C
ORONIS
F
USION
6MP Display System)
the output resolution of the graphic board(s) is determined by
the setting in the Preferred Input function in the on-screen
display (Settings menu). After changing this setting you need to
reboot the PC for the graphic board(s) to change the output
resolution accordingly.