Barco Coronis Fusion MDCC 6130 - Manual (Page 40)

Connecting the signal cables
40
Connecting the signal cables
To connect the signal cables to the display:
1. Unpack the display and put it on a solid flat surface.
2. Make sure the computer is turned off.
3. To get access to the connectors, remove the connector
compartment cover (1).
To remove the cover, gently lift the clips (2) at one of the
handles of the connector cover to release that side of the cover.
Then do the same at the other side of the cover. At last remove
the cover.
4. Remove the display stand cover (3) by sliding it upward.
Figure 5: Remove covers before connecting signal cables
5. Connect the signal cables:
1
2
3