Lenze PC-based automation - Manual (Page 42)

Control technology| System manual
Commissioning of the system
General commissioning steps
42
L
DMS 1.3 EN - 02/2011
Safe data • By means of the
»IPC Backup&Restore« program, a
copy of the Compact Flash card
can be made and saved on any En-
gineering PC for backup.
 Backup ( 29)
• Further information can be found
in the following documentation:
– Industrial PC parameter setting
& configuration,
–Software Manual
»IPC Backup&Restore«
»IPC Backup&Restore«
Diagnostics • The control system can be diag-
nosed by means of the "Engineer"
or "Webconfig"
–This, for instance, enables you to
have a look into the logbook of
the Industrial PC.
• If further diagnostics is required
up to the level of the field device,
also use the "Engineer" or "GDC",
depending on the field device ty-
pe, using the gateway function of
the IPC.
»WebConfig«
»Engineer«
»GDC«

Further information about the use of the single engineering tools can be found in
the corresponding software documentation.
Commissioning step Description Engineering tools