Lenze PC-based automation - Manual (Page 46)

Control technology| System manual
System architecture
Function blocks
46
L
DMS 1.3 EN - 02/2011
As soon as the control has been commissioned, no direct coupling should be used anymore
since, depending on the bus system, the real-time capacity of the bus may be disturbed.
6.2 Function blocks
A number of available function blocks offers the opportunity to access parameters of the
Industrial PC from the PLC program. These are the following:
 Device parameters of the Industrial PC,
 Device parameters of the field devices,
 Logbook entries of the Industrial PC.

Further information about the function blocks can be found in the following
documentation:
• Industrial PC - Parameter setting & configuration