Lenze PC-based automation - Manual (Page 6)

Control technology| System manual
About this documentation
6
L
DMS 1.3 EN - 02/2011
Further technical documentation for Lenze components
Further information on Lenze components which can be used in connection with "PC based
Automation" can be found in the following documentation:
Target group
This documentation is intended for qualified personnel in accordance with IEC 364.
Mounting & wiring Legend:
 MA 8400 StateLine/HighLine  Printed documentation
 MA 9400 StateLine/HighLine  Online help/PDF
 MA EPM-Txxx (I/O system IP20) Abbreviations used:
 MA EPM-Sxxx (I/O system 1000) SHB System Manual
 MA 8200 vector BA Operating Instructions
 EMC-compliant wiring 8200 vector MA Mounting Instructions
 MA ECSxS/P/M/A axis modules SW Software manual
 MA ECSxE power supply modules KHB Communication manual
Accordingly for built-in variants:
• Built-in unit
• Push-through technique
• Cold plate technique
 MA communication card MC-CAN2
 MA communication card MC-ETC
 MA communication card MC-ETH
 MA communication card MC-PBM
 MAs for communication modules
Parameterisation, configuration, commissioning

SW 8400 StateLine frequency inverter
 SW 9400 StateLine/HighLine/PLC controller
 9400 HighLine commissioning guideline
 SHB I/O system IP20 (EPM-Txxx)
 SHB I/O system 1000 (EPM-Sxxx)
 SHB 8200 vector
 BA ECSxS "Speed and Torque" axis module
 BA ECSxP "Posi & Shaft" axis module
 BA ECSxM "Motion" axis module
 BA ECSxA "Application" axis module
 BA ECSxE power supply module
 KHBs for communication modules
Programming

SW 9400 function library
Establishing a network

KHBs for communication modules