Lenze Cam Designer Basic - Manual (Page 24)

Cam Designer Basic
Operation
Create a new project
24 2.1 EN - 09/2005
L

How to define the properties of the master...
1. Go to the Master dialog box and select the properties of the master.
• The Name of the master is indicated on your worksheet.
• The Cycles are the maximum number of operating cycles per minute.
2. Click Next to proceed with the next step.
6.1.2 Step 2: Defining the properties of the slave axis
The entries in the axes reflect the machine constants. Therefore, only work with real val-
ues.
 Enter the indicated values into the dialog box Slave.

Note!
If you use a virtual master, enter in the group field "Machine" under "Gearbox
factor" 100 in the input field z2 and 1 in the input field z1. This serves to achieve
a higher resolution of the master angle.