Lenze Cam Designer Basic - Manual (Page 7)

L
2.1 EN - 09/2005 7
Cam Designer Basic
System requirements
Connection with the target system
2 System requirements
The following minimum requirements on hardware and software must be met to use the
»Cam Designer Basic«.
 Microsoft® Windows® 98, Windows NT® 4.0 (as of Service Pack 5),
Windows® 2000 (as of Service Pack 2) or Windows® XP.
 64 MByte RAM
128 MByte RAM (Windows® XP/2000)
 IBM compatible PC (CPU: Pentium 90 MHz processor or faster)
 Super VGA screen
 Hard disk with at least 120 MB of free disk space
 CD-ROM drive
 Mouse (Microsoft-compatible)
2.1 Connection with the target system
The communication with the target system (controller, Servo PLC or 9300EK servo cam) re-
quires a fieldbus-specific interface module for the PC and the corresponding fieldbus mod-
ules for the target systems to be connected.
For system bus (CAN) communication, Lenze offers the following components as interface
module for the PC:
Bus system Max. number of target systems
PC port Required hardware components
System bus (CANopen) 63
Parallel
port
(LPT port)
PC system bus adapter 2173
incl. connection cable and voltage-supply adapter
• for DIN keyboard connection
(EMF2173IB)
• for PS/2 keyboard connection
(EMF2173IBV002)
• for PS/2 keyboard connection with electrical isolation
(EMF2173IBV003)
USB
(Universal Serial Bus)
PC system bus adapter 2177
incl. connection cable
(EMF2177IB)