Lenze Cam Designer Basic - Manual (Page 40)

Cam Designer Basic
Functions
Interpolation mode
40 2.1 EN - 09/2005
L
7.4 Interpolation mode
In Interpolation Mode, a table of base points is generated from the ideal cam. These value
pairs can then be transferred to the selected target system (Servo PLC,
ECS EA... or 9300EK servo cam).
Uniform distribution of the base points
All points are distributed with the same spacing along the domain.
7.5 Worksteps required for a new cam
The following steps are required to create a new cam:
Settings of the worksheet
( 41)
Creation of profiles
( 41)

Note!
Before executing the interpolation, ensure that the curve trace is closed.