MAMAC Systems IP-SM-101 - Manual (Page 14)

SECTION 3 - Network Configuration Options
3.0.0
© Copyright 2009 ® Registered trademark MAMAC SYSTEMS, Inc.
13 of 17
DN IS-IPSM101.1
Router
Ethernet Hub Router
Bridge Router Wireless Router
Configuration 1
Configuration 2
Configuration 3
Cat 5 Patchcord Cable
Cat 5 Patchcord Cable
Cat 5 Patchcord Cable
Static IP Address: After the initial configuration, power down the appliance by unplugging the
power terminal block and disconnect the crossover cable. CAUTION: Each time the static IP
is changed, power cycle the appliance to load up the new static IP . Connect the
Maverick to the ethernet as shown in Figure 6. Three options are available -- 1) Use a CAT 5
patchcord and plug it into a hub or switch and connect the hub/switch to a router on the web. 2)
Use a CAT 5 cable to connect directly to the router. 3) Configure an Ethernet Bridge and router
and connect the appliance to the Bridge with a CAT 5 cable. For more information on wireless
802.11 B/G configuration, please refer to AN IP802.11.
Connect the pulse input as shown in Figure 3 (Section 1.4.2). Power up the appliance. To connect
to the appliance, launch a web browser (Internet Explorer or Firefox) on a laptop/PC, PDA or
web-enabled mobile/cell phone. Delete all text in the browser address bar and punch in the static IP
address and hit enter. The Maverick will connect and the Main page will launch. Have fun!
Figure 6
IP
Sub Metering
Appliance
IP
Sub Metering
Appliance
IP
Sub Metering
Appliance