MAMAC Systems IP-SM-101 - Manual (Page 15)

SECTION 3 - Network Configuration Options
3.0.1
© Copyright 2009 ® Registered trademark MAMAC SYSTEMS, Inc.
14 of 17
DN IS-IPSM101.1
DHCP IP Assignment: If during initial configuration DHCP was enabled, power down the
appliance and disconnect the crossover cable. Connect the Maverick to the ethernet as shown in
Figure 6. Three options are available -- 1) Use a CAT 5 patchcord and plug it into a hub or switch
and connect the hub/switch to a router on the web. 2) Use a CAT 5 cable to connect directly to
the router. 3) Configure an Ethernet Bridge and router and connect the appliance to the Bridge
with a CAT 5 cable. For more information on wireless 802.11 B/G configuration, please refer to
AN IP802.11.
Connect the pulse input as shown in Figure 3 (Section 1.4.2). Power up the appliance. As soon as
the Maverick comes on line, it will search for a DHCP server and lease a new IP assignment. As
soon as it gets a new DHCP IP, it will send an email to one or both email addresses with the new
DHCP IP. Once you receive the email, connect a laptop/PC, PDA or web-enabled mobile/cell
phone to the same network and launch the web browser. Enter the appliance internal IP address
and connect. Each time the DHCP server assigns a new IP to the appliance, an email will be
generated to keep the user abreast of the latest DHCP-assigned internal IP of the Maverick.