MTS SWIFT 50 GLP Sensor Heavy Trucks User Manual
Page 15
Overview
SWIFT 50 GLP Sensors
Hardware Overview
15
Do not disassemble the SWIFT sensor, Transducer Interface (TI) electronics,
and accessory components.
The SWIFT sensor, TI electronics, and accessory components are not
intended to be disassembled, other than as outlined in “Troubleshooting”.
Disassembling or tampering with these components may result in damage to the
sensor, loss of watertight seal, and voiding of the warranty.
•
The sensor assembly should be returned to MTS annually for recalibration
and inspection.
•
Clean the sensor assembly after each use, as described in
beginning on
, especially if it is exposed to corrosive or abrasive
material, such as salt or sand.
•
Read and follow all warnings and cautions affixed to the transducer and in
this manual especially those warnings and cautions that deal with
installation, use, inspection and maintenance of the transducer.
The SWIFT sensor
assembly should not:
•
Be bumped into hard surfaces or objects while driving the vehicle.
•
Be driven through grass or brush that is taller than the bottom edge of the
sensor.
•
Be exposed to loads that exceed the full scale calibrated ranges, as listed in
•
Be used if the integrity of the sealed cover has been compromised or the
warning labels removed.
•
Be used if the sensor assembly shows indications of damage (such as dents,
bent slip ring bracket arms, a bent anti-rotate assembly, etc.).
•
Be used if any part of the assembly has been modified without explicit,
written authorization from MTS.
CAUTION