MTS SWIFT 50 GLP Sensor Heavy Trucks User Manual
Page 50
SWIFT 50 GLP Sensors
50
Road and Track Vehicles
Installation
6. Repeat steps 1 through 5 for each corner.
Bolt Torque Sequence
7. Install the vehicle on the road simulator.
Refer to the instructions in your road simulator operation manual.
8. Attach the connector housing (or the slip ring bracket and slip ring) to each
transducer.
9. Attach the appropriate cables from the connector housing or one cable from
the slip ring to the TI or data acquisition.
A.
Connect the cable from the Load connector on the connector housing,
or from the slip-ring connector, to the transducer connector on the slip-
ring daughter board of the TI box(es).
B.
If used, connect the cable from the Accel connector on the connector
housing to your data acquisition device.
Connector Side
S50-47
329 Simulator and Hub Mount Side
1 through 10 = M22
(modified lug nuts)
A through H = M10 bolts
1 through 16 = M16 bolts
M5 Threaded
Holes (4)