Multiquip ST70 - Manual (Page 10)

PAGE 10 — ST-70 — PARTS & OPERATION MANUAL — REV. #4 (05/29/07)
MODEL ST-70
THE OPERATOR IS IN COMPLETE CHARGE OF THE PUMP
AND DELIVERY SYSTEM AND IS RESPONSIBLE FOR HIS/
HER OWN SAFETY AND TO WARN AND KEEP ALL OTHERS
OUT OF DANGER.
Do not attempt to operate this equipment without a
thorough understanding of this Parts and Operation
Manual:
1. To prevent damage to equipment or injury to personnel, the
following instruction must be followed carefully:
A. A copy of this manual and all others shall accompany the
pump at all times.
B. This equipment shall be operated only by experienced
operators or students under the direct supervision of an
experienced operator.
C. No unauthorized persons shall be permitted to assist or
remain in the vicinity of the unit while it is in operation, or
during the, inspection, cleaning or repair for the make-ready
operation.
D. This equipment shall not be towed or operated by individuals
who cannot read and understand the signs, decals or
operating instructions.
E. This equipment shall not be operated by individuals under
the influence of alcohol or drugs.
F. Before towing, check the hitch and secure the breakaway
cable and safety chain to the towing vehicle.
G. Tow only with a vehicle and hitch rated to pull a 5000 lb.
load.
H. Use only a 2" one-piece, all-steel machined or forged ball
rated for a minimum of 5000 lbs.
I. Before start-up, check the hopper and remove all
obstructions.
J. Keep hands, feet and human body parts out of the hopper
when the engine is running.
K. The engine must be turned off before performing any
service operations. The engine is remote controlled and
may start pumping any time the engine is running.
L. Do not use worn hoses or hose couplings – inspect daily.
M. Replace any worn or damaged hoses, or couplings,
immediately.
N. Do not disconnect the hose couplings or nozzles while
under pressure.
ST-70 — SAFETY INSTRUCTIONS
O. Never fill the fuel tank while the engine is running or hot.
Avoid the possibility of spilled fuel which may cause a fire.
P. Always carry a fire extinguisher of adequate size and a
first aid kit.
Q. Always wear a safety helmet and safety glasses when on
a job site pumping.
R. Always have the hopper grate securely in place when
pumping.
S. Pump in reverse when the shuttle valve or delivery system
is plugged.
T. Guards, grates, covers, etc. MUST NOT be removed or
altered.
U. If a failure or malfunction occurs, stop the pump and make
all necessary repairs immediately.
V. Electrical and manual controls must always be in working
order.
W. NEVER stand on the hopper grate.
X. Always position the pump on safe, solid, level ground, using
the jack stands.