Multiquip ST70 - Manual (Page 20)

PAGE 20 — ST-70 — PARTS & OPERATION MANUAL — REV. #4 (05/29/07)
This section is intended to assist the operator with the initial
start-up of the MAYCO ST-70 Concrete Pump. It is extremely
important that this section be read carefully before attempting
to use the pump in the field.
DO NOT proceed to the Operating Procedures (field use) of
this manual until this section is thoroughly understood.
NOTE:
Failure to understand the operation of the MAYCO ST-70
Concrete pump could result in severe damage to the pump or
personal injury.
Figure 1 illustrates the basic operating controls and indicators
on the MAYCO ST-70 Concrete pump. Each of the items
referenced will be discussed. The sequence will be as follows:
1. Engine Oil
2. Hydraulic Oil
3. Fuel
4. Rear Stabilizer Stands
5. Emergency Stop Switch
6. Ignition Switch
7. Status Indicators
8. Control Switch, Engine Throttle Control
9. Volume Control
10. Engine Speed, Cooling Fan
11. Pressure Test
12. Hopper Remixer Control Lever
13. Manual and Radio Control
14. Cylinder Lubrication
INITIAL START-UP PROCEDURE
Figure 1. MAYCO ST–70
Controls and Indicators