Multiquip ST70 - Manual (Page 8)

PAGE 8 — ST-70 — PARTS & OPERATION MANUAL — REV. #4 (05/29/07)
READ THIS PARTS AND OPERATION MANUAL
THOROUGHLY BEFORE USING THIS MACHINE. It describes
the safe, proper and most efficient way to operate it. KNOW
YOUR MACHINE!
„ When operating concrete pumps the safety regulations of
the responsible employers’ liability insurance company must
be observed. The observation of these regulations shall be
the responsibility of the contractor and operator.
„ The following are some supplementary recommendations:
„ All safety devices and provisions against accidents such as
warning labels and information signs, coverings, etc. must
be in place. Do not remove or tamper with them. If they are
missing, replace them.
„ Check the operational reliability of the machine each time
before it is put into operation. Any defects found must be
repaired immediately.
„ Allow the machine to be operated and maintained by qualified
personnel only.
„ Before leaving the machine, protect it from unauthorized use
and unintentional movements.
„ Unauthorized presence in the immediate area of the concrete
pump is not allowed. Warn persons who are in the immediate
area. Stop work if persons do not leave the area after having
been warned.
„ Wear personal protective equipment when operating the
machine.
„ W W W W WARNING! DANGER OF AMPUT ARNING! DANGER OF AMPUT ARNING! DANGER OF AMPUT ARNING! DANGER OF AMPUT ARNING! DANGER OF AMPUTA A A A ATION! TION! TION! TION! TION!
Never place your hands or any part of your body in the hopper
or allow anyone else to do so while the engine is running or
when there is accumulator hydraulic pressure or series injury
could result.
ST-70 — SAFETY INSTRUCTIONS
TRAVEL AND TRANSPORTATION
The machine must not be moved with extended outriggers.
Before traveling, check the transportation safety devices of
the outriggers, the tire pressure and the functioning of the
brakes.
Use hoisting units with transport devices complying with safety
requirements.
Hoisting cables or equipment are to be applied only at the
lifting points provided.
TOWING:
1. Read the Atwood Hydraulic Surge Brake Installation
Instructions.
2. The pump should not be towed in excess of 55 MPH (less
depending on road conditions). It can be towed with any
truck rated to pull a 5000 lb. load.
3. Before towing, check with local and state laws for proper
compliance. (Refer to page 31)
a. Secure the hitch on the ball and attach the breakaway
cable and safety chain to the towing vehicle.
b. Raise all stand pipes and secure.
4. Use only a 2” one-piece, all-steel, machined or forged ball
rated at 5000 lbs. minimum capacity.
5. Do not tow the pump with concrete in the hopper.
6. Do not tow the pump with the concrete reducers attached.
7. Check all wheel lug bolts for proper tightness prior to towing.