BridgeWave SLE100 - Manual (Page 18)

TM
SLE100 Installation Manual
13 590-00532, rev A
Pole Mounting Instructions
The pole mount kit can be used to secure the mount to a pole with diameter from 2.0 to 4.5 inches (50
to 115 mm). Listed below are the steps required to assemble the bracket for a pole mount application:
1. Pre-assemble the pole mount brackets by attaching the 4 All-Thread rods to two of the pole
mount brackets using eight ⅜-16 x ¾ hex nuts and four each ⅜ split lock washers, and ⅜ # 8
flat washers, as shown in Figure 3-4. This creates a U-Bolt type arrangement.
Figure 3-4 Pole-Mount Bracket Assembly
The ⅜-16 x ¾ hex nuts on the inside of the pole clamps do not
require any washers since they are only holding the threaded rods
in place and do not bear any load. These hex nuts secure the All
Thread rods to the pole clamps making it easier to align the
clamps on each side of the pole.
2. Attach two pole mount brackets to the wall-mounting bracket using 4 each ⅜-16 x ¾ bolts, ⅜
Split lock washers, and ⅜ # 8 flat washers.