BridgeWave SLE100 - Manual (Page 21)

TM
SLE100 Installation Manual
16 590-00532, rev A
3.5 Radio Installation
Perform the following steps to attach the radio to the Yoke Mounting Bracket:
1. Determine desired polarization of the link, vertical or horizontal, and orient the radio
accordingly using the diamond shaped polarity indication stickers shown in Figure 3-8.
When the radio comes from the factory, the mounting plates are in
the vertical polarization position, that is, the diamond
marking on
the front of the radio housing is to the right when viewed from the
front. For horizontal polarization, the mounting plates should be
moved so that the diamond is at the top when viewed from the
front. Verify that the flexible conduit entrance is on one of the
lower sides of the radio.
Figure 3-8: Polarization Diamond Orientations
The blue color label indicates a high band radio and the red color
label indicates a low band radio