Retsch AS 200 control - natural frequency - Manual (Page 12)

Retsch GmbH 12
Operation
Operating elements and operation
A Cold apparatus plug combination
C Fuse compartment with 2 glass fuses
B Serial connection
D Protective cap for serial connection
E Switch ON / OFF, bottom left
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
1 PROG – button for calling preset sieving parameters P1-P9 or on and for ending
programming without storing the parameters.
2 Display memory shows the selected programme P1-P9 or on. If the AS 200 is driven by
the EasySieve ® softwear programme ES appears in the display.
3 SET – button for activating the setting mode for the preselected programme positions P1-
P9 and for storing the parameters after programming.
4 ▬ button reduces the amplitude 0.20 – 3.00mm, precision ±0.1mm, or sieve bottom
acceleration in „g“
5 Display amplitude shows the amplitude (2 x amplitude) of 0.20 – 3.00mm or sieve
bottom acceleration in „g“.
6 +
button increases the amplitude, 0.20 – 3.00mm, precision ±0.1mm, or sieve bottom
acceleration in „g“.
7 ▬ button reduces the interval time, 10 – 99sec.
8 Display interval shows the preselected interval time, 10 – 99sec.
9 +
button increases the interval time, 10 – 99sec.
10 Button switches interval operation ON, left LED lights up.
11 Button switchces interval operation OFF, right LED lights up.
12 ▬ button reduces the sieving time, 1 – 99min.
13 Display time shows the preselected sieving time, 1 – 99min.
14 +
button increases the sieving time, 1 – 99min.
15 START button starts the sieving process and the green LED lights up.
16 STOP button stops and ends the sieving process and the red LED lights up.