Retsch AS 200 control - natural frequency User Manual
Page 15
Retsch GmbH
15
Operation of the AS 200 control
Switching on / off
E
The main switch E is located on the front left-hand side of the AS
200 control under the control strip.
Switch on the main switch.
In the memory display the last used function (on
or P1 – P9) lights up.
In the amplitude display the last used amplitude
lights up.
The LED interval on or off lights up.
In the time display the last used time lights up.
The AS 200 control is now immediately ready for operation.
Starting – interruption - stopping
5
15
16
Starting:
Press START / button 15
The green LED over button 15 lights up
Running up the machine to the preselected value can be seen
in the display 5.
Interruption (pause function) :
Press STOP / button 16 once
The red LED over button 16 lights up
Values remain visible
Press START / button 15
The sieving process is continued
Stopping (standby function):
Press STOP / button 16 twice
The red LED over button 16 lights up
The complete display goes out except “on”
Activate LED indicators = press button 15 once
New values can be entered
Press START / button 15 a second time
Function is carried out as for Starting
Interval – continuous operation
7
8
9
10
11
When switching on the AS 200 control interval operation is still
switched off.
Switching on interval from 10-99 sec.:
Press button 10
LED over button 10 lights up
Display 8 shows 10 sec.
Button 9 increases the interval time up to 99 sec. If 99 sec is
exceeded the display begins with 10 sec again.
Button 7 reduces the interval time down to 10 sec. If the value
drops below 10 sec the display begins with 99 sec again.
Switching off interval:
Press button 11
LED over button 11 lights up
Display 8 goes out