Robustel R3000 Lite User Guide - Manual (Page 53)

Robustel GoRugged R3000 Lite User Guide
RT_UG_R3000 Lite_v.1.0.0 23.12.2013 52 / 113
Confidential
employs the hop count as a routing metric. RIP prevents routing loops by
implementing a limit on the number of hops allowed in a path from the source to
a destination.
Enable RIP Protocol
Setting
Tick to enable RIP function. Disable
RIP Protocol Version Select from “RIPv1” and “RIPv2”. RIPv1
Neighbor IP
If you input this neighbor IP, router will only send RIP request massage to this IP
instead of broadcast. This item only needs to be set in some unicast network.
0.0.0.0
Update times Defines the interval between routing updates. 30
Timeout
Defines the route aging time. If no update for a route is received after the aging
time elapses, the metric of the route is set to 16 in the routing table.
180
Garbage
Defines the interval from when the metric of a route becomes 16 to when it is
deleted from the routing table. During the Garbage-Collect timer length, RIP
advertises the route with the routing metric set to 16. If no update is announced
for that route after the Garbage-Collect timer expires, the route will be deleted
from the routing table.
120
Enable Advance Tick to enable RIP protocol Advance Setting. Disable
Default Metric This value is used for redistributed routes. 1
Distance
The first criterion that a router uses to determine which routing protocol to use if
two protocols provide route information for the same destination.
120
Passive
Select from “None”, “Eth0”, and “Default”.
This command sets the specified interface to passive mode. On passive mode
interface, all receiving packets are processed as normal and Rip info does not
send either multicast or unicast RIP packets except to RIP neighbors specified
with neighbor command.
The default is to be passive on all interfaces.
None
Enable Default
Origination
Enable to make router send the default route to the other routers which in the
same IGP AS.
Disable
Enable Redistribute
Connect
Redistribute connected routes into the RIP tables. Disable
Enable Redistribute
Static
Redistributes routing information from static route entries into the RIP tables. Disable
Enable Redistribute
OSPF
Redistributes routing information from OSPF route entries into the RIP tables. Disable
Network List Router will only report the RIP information in this list to its neighbor. Null
Network Address Enter the Network address which Eth0 or Eth 1 connects directly. Null
Netmask Enter the Network’s Netmask which Eth0 or Eth 1 connects directly. Null
OSPF @ IP Routing