Sensaphone Express II - Manual (Page 61)

59
Chapter 8: Reaching Express II by Telephone
CHAPTER 8: REACHING EXPRESS II BY TELEPHONE
Express II is at your disposal whenever you need it—no matter where you are. And it’s as easy
as dialing your telephone! All you need is your Express II’s phone number and a Touch-Tone
phone.
Simply follow these first steps to reach Express II’s built-in, voice-guided system. The voice-
guided system comprises a main menu and proceeding sub-menus. It works much the same as
when you are programming Express II. The only difference is that you use the telephone dial
pad in place of the Express II keypad.
Phone-in Parameters:
Dial the phone number of your Express II unit.
Express II will pick-up and “say”:
“Hello, this is... (programmed ID message that you record)”
Enter Password (if you programmed one)
" Press 1 for Status."
" 2 for Alarm."
" 3 to Inquire Programming."
" 4 to Change Programming."
" 5 to Exit."
The Main Menu:
“Press 1 for Status.”
The response for this function is the same as the response to [Inquire] [Status] at the local
keypad. (See Chapter 7)
“2 for Alarm.”
The response for this function is the same as the response for [Inquire] [Alarm] at the local
keypad. (See Chapter 7)
“3 to Inquire Programming.”
Press 3 for a list of the 10 programming categories (See the primary menu categories in Chapter
5). Once a category is chosen, the menus and responses are identical to those if you were
inquiring a programming parameter status at the local keypad.
“4 to Change Programming.”
Press 4 for a list of the 10 programming categories. (See the primary menu categories in
Chapter 5) Once a category is chosen, the menus and responses are identical to programming
at the local keypad.
“5 to Exit.”
Press 5 and the unit will respond, “Have a good day!” The unit will then hang up.
Chapter 8: Reaching Express II by Telephone