Regency Horizon HZ54EPV Large Gas Fireplace - Manual (Page 18)

18
Regency Horizon HZ54EPV Gas Fireplace
INSTALLATION
GAS POWER VENT INSTALLATION
RIGID PIPE ONLY
Firestop Spacer
(included w/power vent kit)
BX Cable
(sold separately)
Rigid Pipe Adaptor
(included w/unit
Frame Assembly
(included w/power vent kit)
Power Vent Terminal
(946-705)
Reducer 5" x 8" to 4 " x 6-5/8"
(included w/unit - Required)
Slip Section
(sold separately)
POWER VENT SYSTEMS ARE FOR USE WITH RIGID PIPE ONLY.
See venting in this manual for detailed instructions.
The Power Vent System is a Direct Vent Terminal designed to allow installation of gas appliances where typical vent confi gurations cannot be achieved.
These installation instructions must be used in conjunction with the appliance and appropriate Power Vent components installation instructions.
120 Volt power supply is required to operate this system (see Electrical Installation section in this manual).
Clearances listed in these Instructions supersede those in the appliance's Installation Instructions.
946-705 Power Vent Kit with Vent Terminal
Parts Required
1 770-994 Rigid Pipe adaptor included with unit
1 946-606 Reducer (required) included with unit
1 58 DVA-08A 8-1/2" Slip section - or sold separately
1 58 DVA-16A 16" Slip section sold separately
1 911-046 Power Vent Fan included w/power vent kit
1 Firestop included w/power vent kit
946-706 20' 5-wire BX cable or sold separately
946-707 60' 5-wire BX cable sold separately
amount required
for install 5" x 8" Rigid Pipe sold separately
1 946-705 Power Vent Kit sold separately
Models Equipped with Surefi re Ignition
The power vent system can only be used with units that have been tested with the Regency Power Vent system.
Downward vertical vent runs are permitted with the Surefi re Ignition system. See vent confi guration in this manual.
5" x 8" Rigid pipe lengths
(sold separately)