Regency Horizon HZ54EPV Large Gas Fireplace - Manual (Page 40)

40
Regency Horizon HZ54EPV Gas Fireplace
INSTALLATION
OPTIONAL REFLECTIVE PANEL INSTALLATION
1) Position the left side panel in place - top of panel in fi rst, then fi t the
bottom tab into the slot at the bottom of the fi rebox as shown below.
Repeat for right side panel.
Fit side panel tab into slot
Left Side
Panel
Shown
Left side panel in position
2) Fit the back panel into position by clearing the pilot shield - bottom
of panel goes in fi rst.
Then fi t the tabs on the bottom left and right side of the back panel
into the slots at the base of the fi rebox.
Secure the back panel in place by placing the brackets over the
screws on the top of the inside left and right side of the fi rebox and
tighten the screw to hold the bracket against the back panel shown
below.
Right side back panel tab fi tted into slot
Bracket shown in place on right side of the fi rebox
Right side panel in position
Before installation, panels must be handled and cleaned as per instructions noted below:
Stainless Steel Panels Black Enamel Panels
•
Stainless panels must be inspected for scratches and dimples prior
to installation. All claims to be recorded at this time.
Claims for damage after installation will not receive consideration.
•
Black Enamel panels must be inspected for scratches and dimples
prior to installation. All claims to be recorded at this time.
Claims for damage after installation will not receive consideration.
•
Use a hair dryer to remove the protective coating from the panels.
•
To protect the fi nish during installation and handling - cotton gloves
MUST be worn at all times while handling the panels.
•
Stainless panels will discolor a little during normal operation.
This is normal and should not be considered a defect.
•
Black Enamel panels will discolor a little during normal operation. This
is normal and should not be considered a defect.
* All hand and fi nger marks MUST be cleaned off with a soft cloth and
a stainless steel cleaner. Most stainless steel cleaners leave a fi lm/
residue on the surface of the panels. Use an ammonia based cleaner
(ie. glass cleaner) to remove this fi lm before applying heat to the unit.
Failure to do this will result in burn stains on panels which you
will be unable to remove.
Not protected by product warranty.
* All hand and fi nger marks MUST be cleaned off with a soft cloth. Use
an ammonia based cleaner (ie. glass cleaner) to remove any fi ngerprints
before applying heat to the unit.
Failure to do this will result in burn stain on panels which you
will be unable to remove.
Not protected by product warranty.
90 degree
bend faces
towards center
of unit on both
left and right
side panels
Left Side
Bracket