Installation, Valve cover removal – Regency Horizon HZ54EPV Large Gas Fireplace User Manual
Page 31
Advertising
Regency Horizon HZ54EPV Gas Fireplace
31
INSTALLATION
VALVE COVER REMOVAL
The valve cover will need to be removed to access the valve tray (see valve
tray replacement) and also to access the DBFC (see Battery + ON/OFF
switch installation).
1) Remove Faceplate and glass door if installed.
2) The valve cover is located on the right side underneath the glass door -
loosen 2 screws securing the valve cover (see Diagram 1 below).
Valve cover
Diagram 1
Diagram 2
Diagram 3
3) Slide the valve cover upward.
4) Lift the cover up off the screws and out of the unit.
5) To install - reverse steps.
Advertising