Talos Security DR1600 Series DVR User Manual - Manual (Page 10)

10
TIP: When using the remote control to
enter password and camera titles,
select the field using the navigation
buttons press ENTER, and then press
the number buttons.
3.2 REMOTE CONTROL OPERATION
The remote control is the secondary device for navigating the system’s
interface.
1. STANDBY: Press to turn on/off standby mode.
2. LOGIN/LOCK: If "Security" has been enabled in the
setup menu, press to open the user login screen.
3. Number/Channel buttons: While in menus
buttons enter values; during live viewing, press to
view channels in full-screen.
4.
: Press to switch between quad and split-screen.
5. MENU: Opens the main menu.
6. PTZ: Opens the PTZ control interface.
7. EXIT: Close menu windows.
8. Navigation/OK:
•
: Move cursor in menus up, Channel up.
• : Move cursor in menus right, Channel up, During
playback increases forward playback speed.
•
: Move cursor in menus left, Channel down, During
playback increase reverse playback speed.
•
: Move cursor in menus down, Channel down.
• OK: In menus, press to confirm selections.
9. +/ - : In menus, press to adjust values.
10. RECORD: Press to start manual recording.
11. STOP: Press to stop manual recording.
12. EXTRA: Not applicable.
13. Playback controls:
•
: Increase reverse playback speed 2X, 4X, 8X,16X,32X.
• : Press to start playback.
• : Press to increase forward playback speed 2X,4X,
8X,16X,32X.
•
: Press to slow playback speed by 1/2, 1/4, 1/8, 1/16,1/32.
• : Press to freeze playback, press again to advance
frame-by-frame.
14.AUDIO/MUTE: Not applicable.
3.2.1 Use Remote control to select the device number:
You can control several DVRs using one remote control. Press the "LOGIN/LOCK" key, and enter
the device number to control a specific DVR. The device number is set in "PASSWORD" setup menu.
For example to select the device with number "000001".
Press "LOGIN/LOCK" + "1" for the remote to control DVR as device 1.
NOTE:
1. The remote is set to control a DVR with device number "000000" as the default.
2. Press "LOGIN/LOCK" + "0" for the remote to control and DVR with any device code.
3. The number assigned to a DVR must be lower than 000255.