Talos Security DR1600 Series DVR User Manual - Manual (Page 22)

22
Email: Enable = On, Disable = Off
SSL is a security link transport protocol that allows you to encrypt your communication information,
including your email. Using SSL helps to prevent hackers from monitoring your email or
communication information, even your password. Please confirm with your email service provider
that your email server supports SSL.
SSL: Enable = On, Disable = Off
SMTP (Simple Mail Transfer Protocol) is an internet standard for e-mail transmission via IP
networks.
SMTP Port: The specified send port for the SMTP server (forwarding server/host). In general the
SMTP port is 25, to support G-mail use SMTP port 465. If SSL is enabled use port 465 (default value).
If SSL is disabled use port 25 (default value).
Sender E-mail: Enter your e-mail address.
Sender PWD: Enter your e-mail password.
Receiver E-mail: Enter the e-mail address of the intended recipient.
PTZ SETUP
Click "PTZ" to enter the PTZ settings interface.
CH01~CH04: Click to select and set-up the channel a PTZ camera is connected to.
PROTOCOL: Click to select the camera communication protocol. The DVR supports Pelco-D and -P
protocol, the default is Pelco-D.
BAUD RATE: Click to select the baud rate for your PTZ; 1200, 2400, 4800, or 9600 Bps.
DATA BIT: Click to set data-bit; 5, 6, 7, or 8, the default setting is 8.
STOP BIT: Click to set the stop-bit; 1 or 2, the default setting is 1.
PARITY: Click to set parity; None, Odd, Even, Mark, or Space, the default setting is None.
CRUISE: ON allows the camera to follow a preset cruise path for a designated channel.
OFF turns auto cruise off for a designated channel.
ADDRESS: Set the address or device number of the PTZ camera.