Talos Security DR1600 Series DVR User Manual User Manual
Page 21
21
ALARM SETUP
Click "ALARM" to enter the alarm settings interface.
CH01~CH04: Click to select the channels for alarm setup.
I/O ALARM: Select "ON" or "OFF" for alarm contact closures.
HDD LOSS: Select "Open" to trigger an alarm if there is no HDD, an "H" will display on the bottom
left of channel 1 in live view.
HDD SPACE: Select "Open" to trigger a notification in live view if there is less than 500 MB storage
on the HDD. This is only applicable if HDD Overwrite is enables.
VIDEO LOSS: Select "Open" to display "video loss" in live view when a channel has no video.
ALARM CONTRL: Controls the alarm buzzer output and duration associated with an alarm event.
●
OUTPUT: The alarm output duration can be set to: 0, 10, 20, 40, or 60 seconds.
●
BUZZER: The buzzer output duration can be set to: 0, 10, 20, 40, or 60 seconds.
●
DURATION: The post alarm recording time can be set to: 30 seconds, 1, 2, or 5 minutes.
●
PRE REC: Pre-alarm recording can be set to: Off = Close, or On = Open
Email setup
The DVR can be configured to send an e-mail alert if the DVR senses an alarm event.