Talos Security DK1400 Series Surveillance Kit User Manual - Manual (Page 12)

12
3.4 SYSTEM OPERATION
3.4.1 USER LOGIN
3.4.1.1 STARTING THE SYSTEM
To power the system ON/OFF connect the power cable to the DC 12V port on the rear panel. At
startup, the system performs a basic system check and runs an initial loading sequence. After a few
moments, the system loads a live display view.
1) If there is no HDD in the device, the device can't read the HDD, or the HDD isn't formatted it will
display an "H" in the video on the screen.
2) You must format the HDD in the DVR before first use. The steps as follows: MainMenu >
Device>HDD management > format. When HDD format is complete, the system will restart.
3.4.1.2 SYSTEM LOGIN
By default, passwords are disabled on the system; you do not need to enter a password when
accessing any system menus. However, for security purposes it is highly recommended to enable
passwords on the system using the Password Menu.
If you have enabled password and set up user accounts you will see the following screen when you log
into the DVR. Input device ID and user password and press "Apply" to access the main menu.
NOTE: Default device ID is: 000000. Default Admin password is 519070. Default User password is
000000. To manage the device more conveniently, setup the user passwords and change the device ID
in the base setup. Administrator has full device authority; User has limited authority; view and
playback.
DEVICE ID: Enter the unit ID (000000 ~ 000255)
PASSWORD: Enter the Admin password or User password