Unisteer 8010720-02 Ford Faicon/Comet Power Rack & Pinion 1960-65 - Manual (Page 4)

pg. 4 655610
7. When wheel is removed go under the dash and disconnect wire harness from column to vehicle.
Note: If vehicle does not have a hard-shell connector, disconnect one wire at a time and mark with
number stickers.
8. Remove two retaining bolts under dash that secure column to dash and remove steering column
shell. Note: Do not lose ring around shaft.
9. From under car, remove bolts that retain gearbox to frame. Remove gearbox and shaft from vehicle.
Note: It may be necessary to remove your driver side header if so equipped to gain clearance for
gearbox removal.
10. From under dash, remove six sheet metal bolts that retain to column support place to firewall and
floor. Remove plate and discard.
11. Remove power steering lines, power steering pump, and power steering brackets from engine and
discard.