Unisteer 8010720-02 Ford Faicon/Comet Power Rack & Pinion 1960-65 - Manual (Page 7)

pg. 7 655610
Column Shaft Installation:
1. Your column shaft has been shipped assembled. Install u-joint number 8050640 onto pinion of rack
assembly.
2. From inside vehicle install ring removed from old shaft onto new shaft with taper pointing toward
column.
3. Slide shaft into column and wiggle through bearing in the column tube.
4. You will need a person on the inside of the car to push and hold shaft in place.
5. As shaft passes through bearing and into engine bay, slide brass washer supplied with bearing kit
over shaft against bearing. Then, slide shaft into column u-joint.