Unisteer 8010720-02 Ford Faicon/Comet Power Rack & Pinion 1960-65 - Manual (Page 5)

pg. 5 655610
Installation:
1. Your stock column must be measured from the bottom and one inch cut off.
Note: This must be done in a band saw or something that makes an accurate square cut.
2. Install steering column bearing in bottom side of column tube. Tap bearing into place against lip of
bearing until it stops against column tube.
3. Install new column support plate on firewall using new
attaching hardware.
Note: If your car is equipped with a manual transmission it will be necessary to remove rubber plug from
plate to install your clutch pedal linkage rod.
4. Install column tube and hardware (leave loose). Note: Do Not Install Shaft Yet. From under car,
install column clamp over tabs on column plate and leave loose.
5. From under car it will be necessary to loosen motor mount nuts. Loosen and remove the four nuts
and bolts that hold motor mount to frame. Note: Remove one bolt at a time and replace with longer
3/8 bolts supplied in kit. Note: It may be necessary to jack up on engine a little to relieve pressure off
bolt for removal and installation. Install the bolts so that bolt heads face front bumper.