Using the software, Changing filter settings – UVP ColonyDoc-It Imaging Station User Manual

Page 36

Advertising
background image

ColonyDoc-It Imaging Station

36

Using the Software

Changing Filter Settings

To reduce user initial set-up time, filters were created to count “true” colonies and remove inherent defects from the

sample plate that would (without the filters) be included in the total colony count. The filters may prevent a colony

from being counted based on some critical parameters.

To set new filter parameters, click onto

the

Show Results Window > Filter >

Filter class and drag the pointer to the

filter class to change.

A new

Filter Colonies window will

appear with the following parameters:

Area, Perimeter, Avg Diameter, and

Circularity.

The predefined ranges are defined.

Each parameter can be changed to

accommodate a wide variety of sample

types.

The new range can either be inclusive or exclusive. Click onto the

Keep Range or Exclude range depending on

sample requirements.

Enter the values to keep or exclude. Click

OK.

The software will recount the colonies based on the new filter values.

Advertising
This manual is related to the following products: