WarmlyYours Infinity - Manual (Page 12)

5. SPECIFICATIONS
Item # Model Dimensions Volts Watts Ohms Amps
TW-F10BS-HW Hardwired
W: 3 5/8” (600mm)
H : 32” (811mm)
D: 4 ¾” (121mm)
120 150 95 1.25
TW-F10BS-PL Plug-In
W: 23 5/8” (600mm)
H: 32” (811mm)
D: 4 ¾” (121mm)
120 150 95 1.25
Product Construction - Infinity Towel Warmer
The Infinity Towel Warmers are constructed from Type 304 stainless steel
and have a brushed finish. The stainless steel tubing is pre-assembled and
tack-welded together for rigidity. The towel warmer is heated by a cULus
Listed wire. The tubing used to hang the towel warmer is also made of Type
304 stainless steel with a brushed finish. The plug-in model is equipped
with a UL Listed plug with grounding pin attached to a 6-foot (1.8m) cord.
Connection Method
The plug-in model has a 6-foot cord, which is located on the right side of
the unit. Keep cord location and length in mind and plan accordingly when
determining placement of the towel warmer in the room. The unit must be
plugged into an outlet that is properly grounded. For automatic control of
the plug-in unit, a timer can be used. The Infinity hardwired model is fed
electricity into the towel warmer via a section of stainless steel tubing. The
tubing can rotate to facilitate wiring. The tubing has an outside diameter
suitable to secure the rubber O-ring on the electrical cover plate. The
stainless steel tubing projects through the O-ring and into the front of the
2” x 4” (51mm x 102mm) electrical junction box that is properly grounded.
This box is secured in the wall and, a water resistant seal is made with the
use of the rubber O-ring. Power can then be fed to the control unit, which
may be located anywhere in the room.
Safety Ratings
Infinity Towel Warmers are cULus Listed and are suitable for use in US and
Canadian markets. The timer is UL Listed and CSA certified. The timer is
humidity sealed to IEC standards for Zone 1 (areas where it may be splashed
by water) and Zone 2 (areas which are occasionally subject to high humidity)
and therefore suitable for installation in damp locations, such as bathrooms.
The main electrical line feeding the towel warmer must incorporate an
Appliance Leakage Current Interrupter (ALCI) for North America.
11