WarmlyYours Infinity - Manual (Page 2)

Thank you for choosing a finely crafted WarmlyYours Infinity towel warmer.
The Infinity’s radiant heat gently warms your towel or bathrobe, allowing you
to wrap yourself in luxurious comfort as you step out of the bath or shower.
Included in this document are all necessary installation and operating
instructions.
To locate the model number, refer to the product label as shown in Diagram
D on page 8. If you encounter any difficulties while installing your towel
warmer, installation support is available by phone between 8:00 a.m. and
5:30 p.m. CT, Monday through Friday by calling (800) 875-5285. If a return
is necessary, please use original packaging.
SAFETY INFORMATION
• Never stand, sit on, or hang on the towel warmer unit.
• Never allow children to play on or with the towel warmer.
• Make sure that the electrical circuit breaker is shut off at the main panel before
wiring or servicing your towel warmer.
• The towel warmer must be properly grounded.
• All wiring must be in accordance with the National Electrical Code (NEC)
and Canadian Electrical Code (CEC) and should be performed by a licensed
professional who is certified to do electrical wiring.
• Never place your towel warmer inside a shower, sauna, or steam room.
• Never attempt to warm more than two (2) towels on the towel warmer at a time.
Overloading the towel warmer will cause the unit to become extremely hot and
may result in a burn if touched. (See page 10 for additional information.)
• Infinity towel warmers are cULus listed for use in US and Canadian markets.
• Never use an extension cord (for plug-in model).
CLEANING INFORMATION
Clean the towel warmer with a soft, non-abrasive, damp cloth while warm.
Once the towel warmer has cooled, lightly polish with a soft, dry cloth.
Do not use abrasive cleaning powders, metal polish, or chlorine based
cleaners on any part of the towel warmer.
INSTALLATION
This appliance must be installed in accordance with the instructions in the
manual and the NEC and CEC guidelines relating to electrical fixtures in
bathrooms. The towel warmer must be on a GFCI-protected circuit and be
wired by a professional who is certified to do electrical wiring. If the towel
warmer does not heat upon initial installation, PLEASE VERIFY THAT THE
POWER SWITCH, LOCATED AT THE BOTTOM OF THE LEFT, VERTICAL
POST, IS IN THE ON POSITION.
1