WarmlyYours Infinity - Manual (Page 8)

2. Bracket Assembly Instructions (continued)
Step 1
Measure for bracket positions using the template if desired. At least two brackets
must be attached to a stud.
Step 2
Affix brackets A to the wall using screw g and drywall anchor f where necessary.
Repeat Step 2 for the three remaining brackets.
Step 3
Place and orient the curved end of tubing B with the threaded inserts located at
four points on the back of the towel warmer. Affix tubing B to the threaded inserts
with bolt C and tighten using the large Allen wrench d provided.
Repeat Step 3 for the three remaining sections of tubing.
Step 4
Loosen the hex-head screws h at the base of each section of tubing B using the
smaller Allen wrench e provided. Hang towel warmer by aligning and sliding all
four sections of tubing B over bracket A. Partially tighten hex-head screws h at
the base of each section of tubing B to hold the towel warmer in place but do
NOT fully secure the fasteners at this time.
Step 5
Please remove the protective film from the cover plate.
Plug-In Model Skip Steps 6-8.
Hardwired Model Only
Slide the brushed stainless collar over the end of the stainless steel tubing where
the wires come out of the unit. Make sure to slide the collar over the tubing
so that the larger diameter opening is facing away from the towel warmer and
toward the electrical cover plate that will be placed on the towel warmer next.
Remove the plastic coating from the cover plate. Slide the cover plate over the
same section of stainless steel tubing. Refer to Diagram E. Do not remove
rubber O-ring from electrical plate under any circumstances. Make sure the
cover plate is slid on the tubing so that the back of the cover faces away from the
towel warmer and toward the electrical outlet.
Step 6
Have a certified professional wire the towel warmer to the electrical circuit according
to code, referring to the detailed wiring diagram provided in Diagram F.
Step 7
Push the wires into the electrical box and screw the cover plate to the outside of
the box with the screws provided.
7