WarmlyYours Infinity - Manual (Page 9)

2. Bracket Assembly Instructions (continued)
Step 8
Hardwired Model Only (continued)
Ensure the rubber seal is in position and sealed correctly inside the collar.
Refer to Diagram E. Slide the brushed stainless collar over the tube until
it is touching the face of the O-ring on the cover plate.
Hardwired Model Skip Steps 9-10.
Plug-In Model Only
Plug the cord into a properly grounded outlet. Do NOT use an extension
cord to make the connection between the towel warmer plug and outlet.
Step 9
Hold the towel warmer in place while tightening the hex-head screws h
at the base of each section of tubing B using the smaller Allen wrench e
provided to secure the towel warmer in place.
Step 10
Make sure the unit is turned on using the ON/OFF switch located at the
bottom rail on the left side (when facing the towel warmer). A red light will
illuminate the switch when the switch is turned to the “ON” position. Refer
to Diagram D for switch location.
8
on
off
economy
TOWEL WARMER
Diagram D
O-Ring
Cover Plate
Towel Warmer
Collar
Diagram E
(hardwired model only)
Label
Switch